Appendix B. Problem solving
Computer problems can be caused by hardware, software, or user error.Using
the information in this section, you might be able to solve problems yourself or
gather helpful information that you can pass on to a service technician. You
might also need to refer to your computer, operating system, or sound adapter
documentation.
Review the following list for any problem description that might fit your
situation.
vYour computer or DVD-ROM drive does not operate correctly,or the busy
indicator light does not come on.
Take the following actions:
1. Check that the disc is loaded with the label side up.
2. Check that all devices and cables are properly connected to the computer
and to the electrical outlet.
3. Turn off the computer,unplug the cables for your computer and all
attached devices, and remove the computer cover.
4. Check that all power and Combo cables are securely attached. Disconnect
the Combo cable and check for bent or misaligned pins. If you do not
find any problems, reconnect the interface cable. Replace the computer
cover, and reattach all cables and power cords.Turn on the computer,
restart the operating system, and attempt to open the loading tray by
pressing the Open/Close button. If the tray fails to open and the busy
indicator does not light, turn off the computer and try using another
4-pin dc power cable.
5. Check that the color-coded edge on the Combo cable aligns with pin 1
on the IDE port and is closest to the power cable on the DVD-ROM
drive.
6. Check the DVD-ROM drive and any other device on the Combo cable for
the proper settings..
7. If the middle connector on the Combo cable is attached to the IDE port
on the system board, remove the connector and reattach the cable. If
there is only one device on the IDE port, attach the connector at one end
of the cable to the IDE port and the connector at the other end to the
device, leaving the middle connector (if there is one) open.
If there are two devices on the IDE port, attach the connector at one end
of the cable to the IDE port. If there is a hard disk drive, attach it to the
connector at the other end of the cable, and attach the DVD-ROM drive
to the middle connector.
vYou cannot access the DVD-ROM drive, or the DVD-ROM (CD-ROM)
icon is not displayed.
© Copyright IBM Corp. 2001 B-1