IBM 600X (MT 2646) manual Product overview, Features, Power overload

Product overview

ŸUniversal serial bus test with the USB test cable

Ÿ	Parallel port		test	with the	wrap plug inst
	the port	replicator
10. If diagnostic			errors appear,		replace the
or	the diskette drive. If the problem rema
replacement,		replace		the system	board.

11.If power problems appear only when the po replicator is used, replace the port replic

Power overload:		If power shutdown occurs
intermittently when PC			Card	devices	are	used	thr
port	replicator	with	PC Card slots, suspect a				pr
over-current. Some		PC	Card devices use more power
the	maximum use	of	each	device	occurs	simultane

the total current will exceed the limit, causing shutdown. Isolate this problem by removing one of

devices, and	using the computer under the same
If a power	shutdown occurs, you have found th

the problem. If not, do this procedure for all devices until you determine the cause.

Product overview

This section presents the following product-unique information:

Ÿ“Features”

Ÿ “Status indicators” on page 15

Ÿ“Fn key combinations” on page 16

Features

The	following table		is	an overview			of		the	syste
of	the ThinkPad	600X:
Feature		Description
Processor		Ÿ				III		450	MHz, L2
			Intel		Pentium
			cache
		Ÿ				III		500	MHz,	L2
			Intel		Pentium
			cache		
		Ÿ	Mobile			III		processor at
					Pentium
			650	MHz	featuring		
							Intel
			SpeedStep technology					running		at

1.6V Bus architecture Ÿ PCI Bus

Memory	Ÿ 64	MB	(on		the system			board) and
(standard)	32	MB	in		the	DIMM	slot
Memory (option)	Ÿ 32	MB,		64	MB,	or	128	MB DIMM
	card (maximum of 320 MB)
CMOS RAM	114 bytes+ 4			Kbytes
Video	Ÿ 13.3-inch, 16M					colors XGA
	(1024×768			resolution)			TFT	color
	LCD

13