![](/images/new-backgrounds/1106445/10644553x1.webp)
The following illustration shows the locations of parts on the system board.
1 Microprocessor | 11 SATA 2 IDE connector |
2 DIMM connector 1 | 12 Promise of value (POV) daughter card |
| (some models) |
3 DIMM connector 2 | 13 Clear CMOS/Recovery jumper |
4 DIMM connector 3 | 14 Battery |
5 DIMM connector 4 | 15 SCSI LED connector |
6 Power connector | 16 PCI slots |
7 Diskette drive connector | 17 Front panel audio connector |
8 PATA primary IDE connector | 18 |
9 PATA secondary IDE connector | 19 AGP slot |
10SATA 1 IDE connector |
|
Installing memory
Your computer has four connectors for installing dual inline memory modules (DIMMs) that provide up to a maximum of 4.0 GB of system memory.
When installing DIMMs, the following rules apply:
vSystem memory is divided into two channels (channel A and B). DIMM connectors 1 and 2 are channel A, and DIMM connectors 3 and 4 are channel B.
vIf DIMM connectors 1 and 3 (or 2 and 4) are filled with the same technology and size of memory, the system operates in dual channel mode.
vUse 2.5 V,
vUse 128 MB, 256 MB, 512 MB or 1.0 GB (when available) DIMMs in any combination.
vDIMMs are 25.4 mm (1.0 inch) in height.
Note: Only DDR SDRAM DIMMs can be used.
Chapter 1. Types 8185, 8186, 8192, 8413, and 8430 11