IBM 8185, 8128, 8413, 8414, 8189, 8195, 8186, 8187, 8188, 8197, 8193 Installing a CD-ROM or DVD-ROM drive

The following illustration shows the locations of the drive bays.

The following list describes some of the drives that you can install in each bay and their height requirements:

1Bay 1 - Maximum height: 25.8 mm (1.0 in.)

2Bay 2 - Maximum height: 43.0 mm (1.7 in.)

3Bay 3 - Maximum height: 25.8 mm (1.0 in.)

3.5-inch diskette drive (preinstalled) CD-ROM drive or DVD-ROM drive (preinstalled in some models)

3.5-inch hard disk drive (preinstalled)

Notes:

1.Drives that are greater than 43.0 mm (1.7 in.) high cannot be installed.

2.Install removable media (tape or CD) drives in the accessible bay (bay 2).

Installing a CD-ROM or DVD-ROM drive

To install a CD-ROM drive or DVD-ROM drive in bay 2, follow these steps:

1.Remove the cover (see “Removing the cover” on page 9).

2.Remove the bay panel from the front bezel.

3.Remove the metal shield from the drive bay by inserting a flat-blade screwdriver into one of the slots and gently prying it loose.

4.Make sure the drive is set correctly as the master device. Refer to the documentation that comes with your CD-ROM drive or DVD-ROM drive for master/slave jumper information.

Chapter 1. Types 8185, 8186, 8192, 8413, and 8430 15