4. If necessary, bolt the rack cabinet to the floor through the provided holes in the
stabilizer brackets.
Removing and installing NetBAY25 panels
The NetBAY25 Rack cabinet comes with side panels installed. Remove the side
panels from a rack cabinet before you install or remove optional devices.
Removing and installing side panels: Use the following procedure to remove
the NetBAY25 side panels:
1. From the inside rear of the rack cabinet, slide the side panel locking bar into the
unlocked position; then, slide the front side panel locking bar into the unlocked
position.
2. Tilt the bottom of the side panel slightly toward you; then, lift the side panel
away from the tabs on the top of the rack cabinet.
3. Repeat this procedure to remove both side panels.
Reverse this procedure to install the side panels. Slide both locking bars into the
locked position to secure the side panel to the rack cabinet.
Side panel
Rear
locking bar
Front
locking
bar
Figure8. Removing the NetBAY25 side panels
12 Hardware Maintenance Manual: IBM PC Server/Enterprise Racks Types 9306, 9308