IBM ARTIC960RxD Installing, Driver, Check System Pre-Requisites, telnet, or rlogin, Technical

Chapter

4.

Installing

the

Device

Driver

on

the

RS/6000

SP

System

In an SP, you need

to do on each node what you normally do

on a

standalone

system. You

must make the installation

files

available and

then

install

them

on

all

the

relevant

nodes.

Perform the

following

tasks on the Control Workstation. You should not need to

telnet

or rlogin

to

the

individual SP nodes. You need to bedshfamiliar with the

command. If not, referParallelto theSystem Support Program for AIX:

Administration GuideorParallel System Support Program for AIX: Command and

Technical

Reference.

If you

are

unable

to

utilize

the

"dsh"

command

because of

the

setup

at

your

then

you

will

have

to

telnet

to

each

node

and

perform

the

steps

below,

omitting

"dsh"

prefix.

Check System Pre-Requisites

1. Log into the Control Workstationroot . as a

2. Go to a temporary directory by typing:

cd /tmp
at the		system		prompt, then		press Enter.
3. Make	a	"working		collective"		file	containing a list of the relevant nodes on
which	you		want	to	perform	the	update in preparation for the dsh command.
Type	the		following,		press Enter		after each line:

cat > group1 nodename1 nodename2 nodename3......

CTRL-D

export WCOLL=/tmp/group1

4.Test the working collective by typing: dsh date

then press Enter. The results should look similar to:

nodename1: Wed Apr 1ð 1ð:37:46 EDT 1996

nodename2: Wed Apr 1ð 1ð:37:46 EDT 1996

nodename3: Wed Apr 1ð 1ð:37:47 EDT 1996

nodename4: Wed Apr 1ð 1ð:37:48 EDT 1996

Chapter 4. Installing the Device Driver on 4-the1SP System