Reinstalling | the | Quad T1/E1 | DTA |
|
| |
The | following | instructions | assume | that | you have the base adapter out of the system | |
unit | and | are | ready to | install | the | mezzanine card. |
Before You Begin
Verify that the jumper on the base adapter is set properly (see page
1.Align the connector on the mezzanine card with the PMC connector on the base adapter.
Attention: |
|
|
|
|
| |
When | the base | adapter | and the mezzanine card are | properly aligned, | the top | of |
the | voltage keying pin on | the base adapter fits into | the voltage key | opening | on | |
the | mezzanine | card. |
|
|
|
|
2. Firmly press the mezzanine card and the base adapter connectors together.
3. Install the four mounting screws; then tighten the screws.
4. Follow the procedure “Jumper Installation Information” on page
