IBM PROJECTOR C400 manual Network Setting menu, Description

2.Press the cursor left/right button to move to the Information menu.

3.Press the cursor up/down button to move up and down in the Information menu. The Information menu is shown below.

The following table shows the options that you will see in the Information menu.

Item	Description
Video Information	Displays the resolution and refresh rate of
	the connected video device.
Software Version	Displays information about the firmware
	version information.
Lamp Hours	Displays lamp hours used information.
Network DHCP	Displays Network DHCP status information.
Network IP Address	Displays IP address information.
Network Setting	Displays the Network Setting menu.
Lamp Mode	Toggles between Normal and ECO lamp
	modes. ECO mode uses less power but
	decreases the lamp brightness
Lamp Hour Reset	Reset this item after replacing the lamp. For
	more information, refer to “Replacing the
	projector lamp” on page A-1
Cancel	Resets Lamp Mode to the default setting.

Network Setting menu

To access the Network Setting menu, follow the steps below:

1.Press the Menu button to open the main menu.

2.Press the cursor left/right button to move to the Information men.

3.Press the cursor up/down button to move to Network Setting in the Information menu.

4.Press the cursor left/right button or the Enter button to select the Network Setting menu. An example Network Setting menu is shown below.

5-8IBM C400 PROJECTOR: User’s Guide