TROUBLESHOOTING 9 
If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center.
PROBLEM | POSSIBLE CAUSE | SOLUTION | REF. |
|
|
|
|
No power comes on. | • The battery is exhausted. | • Recharge the battery pack. | pgs. 25, |
| • Bad connection for the battery pack. | • Check the connection to the | 26 |
|
| transceiver. |
|
|
|
|
|
No sound comes from the | • Squelch level is too deep. | • Set squelch to the threshold point. | pgs. 9, 11 |
speaker. | • Volume level is too low. | • Set [VOL] to a suitable level. |
|
|
|
|
|
Transmitting impossible. | • Some channels are receive only. | • Change channels. | p. 12 |
| • The battery is exhausted. | • Recharge the battery pack. | p. 25 |
|
|
|
|
The displayed channel | • Lock function is activated. | • Push [F], then push [7 (KEY LOCK)]. | p. 10 |
cannot be selected. |
|
|
|
|
|
|
|
Scan does not start. | • All memory channels are not | • Set the “TAG” settings of desired | p. 16 |
| programmed as “TAG” channels. | channels. |
|
|
|
|
|
No beep sounds. | • Beep tones turned OFF. | • Push [F], then push [8 (BEEP)] to | p. 9 |
|
| adjust the beep tone level. |
|
|
|
|
|
29
