2 PANEL DESCRIPTION
!0CLR KEY [CLR (DIAL/YZ)] (continue)
➥Push [CLR] to cancel the SCAN function.
➥ Push [CLR] to cancel the direct frequency enter- ing with digit key.
➥Push [CLR] to turn the squelch level adjusting mode OFF.
!1ANL KEY [ANL (REC)]
➥Push to turn the ANL function ON or OFF.
➥ Push 
, then push [ANL (REC)] to turn the recording function ON. (p. 10)
- The transceiver records the receiving signal or opera- tors voice message by push and holding [PTT] for 20 sec.
!2BANK KEY [BANK (PLAY)]
➥ Push [BANK] to enter the BANK selection mode while memory channel is selected, push [CLR] to exit the BANK selection mode. (p. 12)
➥Push 
, then push [BANK] to play the recorded signals. (p. 10)
!3FUNCTION KEY [F]
Push to call up the function indicator, “ ,”then push another key to access its secondary function.
•“ ”appears for 3 sec. after [F] is pushed; at this time pushing [F] again cancels the indication. (p. 6)
NOTE: In general, “ disappears” when another key is pushed to activate a secondary function. However, some keys which have more than one secondary function, (such as [DUP]), do not cancel “ .”In this case, “ disappears” automatically after 3 sec.
!4MEMORY MODE KEY [MR (MW)] (pgs. 12, 13)
➥ Push [MR] to call the memory channel mode, push [CLR] to exit the memory channel mode.
➥Push 
, then push [MR (MW)] to program the contents into the memory channels.
➥Push [MR] to program the memory comment when the memory comment function is enabled.
!5ENTER KEY [ENT(WX)]
➥ Push [ENT] to enter the numeral input. Enters consecutive zero digits. (p. 8)
➥Push 
, then push [ENT] to enter the weather channel selection mode. (U.S.A. version only) (p. 9)
•Rx/Tx indicator
➥Lights red during the transmit mode.
➥Lights green during receiving a signal or squelch is open.
NOTE: Some functions may not be available depending on version. Please consult your dealer.
4
