Icom IC-FR3000 manual Output, Power, Low, Deviation, Hpf Off Lpf, Modulation, Balance

SOFTWARE ADJUSTMENT – continued

Select an item using [CH-UP] / [CH-DN] buttons, then set specified value using [RPT/BASE] / [MONI] buttons on the

FRONT PANEL.

ADJUSTMENT	ADJUSTMENT CONDITION				MEASUREMENT	VALUE
				UNIT	LOCATION
OUTPUT	1 • LCD display	: A06 HW POWER		Rear	Connect the RF power meter to	50.0 W
POWER	• Operating freq. : 160.2750		MHz [GEN74]	panel	the [TX] antenna connector.	[Other]
(HI)		162.2750	MHz [Other]			25.0 W
	• Connect the RF power meter to the [TX]					[EUR2], [FRG2]
	antenna connector.
	• Transmitting
(LOW)	2 • Push the [PROG] button					10.0 W
	• LCD display	: A06 LW POWER				[Other]
	• Operating freq. : 160.2750		MHz [GEN74]			5.0 W
		162.2750	MHz [Other]			[EUR2], [FRG2]
	• Transmitting
DEVIATION	• LCD display	: A07 LW M DEV		Rear	Connect the FM deviation meter	±4.4 kHz [Other]
	• Operating freq. : 160.2750		MHz [GEN74]	panel	to the [TX] antenna connector	±3.5 kHz [FRG2]
		162.2750	MHz [Other]		through the attenuator.
	• IF bandwidth	: Wide

•Connect the audio generator to the [MIC] jack through the JIG cable and set as:

1.0kHz/40 mVrms

•Set an FM deviation meter as:

HPF	: OFF
LPF	: 20 kHz
De-emphasis: OFF
Detector	: (P–P)/2

•Transmitting

MODULATION	1 • LCD display	: A08 LW LMODC		Rear	Connect the FM deviation meter	±4.4 kHz [Other]
BALANCE	• Operating freq. : 148.2750		MHz [GEN74]	panel	to the [TX] antenna connector	±3.5 kHz [FRG2]
(LOW FRQ.)		150.2750	MHz [Other]		through the attenuator.
	• IF bandwidth	: Wide

•Connect the audio generator to the [MIC] jack through the JIG cable and set as:

1.0kHz/40 mVrms

•Set an FM deviation meter as:

HPF	: OFF
LPF	: 20 kHz
De-emphasis: OFF
Detector	: (P–P)/2

•Transmitting

(HIGH FRQ.)	2 • LCD display	: A09 LW HMODC		±4.4 kHz [Other]
	• Operating freq. : 171.7250		MHz [GEN74]	±3.5 kHz [FRG2]
		173.7250	MHz [Other]
	• Transmitting

*The output level of the standard signal generator (SSG) is indicated as the SSG’s open circuit.

4 - 7