Icom IC-FR3000 manual Entering the Adjustment Mode, Operating in the Adjustment Mode

■ENTERING THE ADJUSTMENT MODE

1 Turn the power OFF.

2 While pushing and holding both [CH-DN] and [CH-UP], turn ON. Never release [CH-DN] and [CH-UP] until 1 short beep sounds.

3 Push [CH-DN] button, then sounds 2 beep audio.

■OPERATING IN THE ADJUSTMENT MODE

[POWER]

[CH-DN] [CH-UP]

• Change the item (including frequency) (+1).	: Push [CH-UP] button.
• Change the item (including frequency) (–1).	: Push [CH-DN] button.
• Adjust the specified value (+1).	: Push [PRT/BASE] button.
• Adjust the specified value (–1).	: Push [MONI] button.
• Change the TX and RX’s condition.	: Push [PROG] button.

Change the condition TX reference frequency to RX reference frequency.

Change the condition TX “HIGH POWER” to TX “LOW POWER”.

[PROG]

[RPT/BASE]

[MONI] [CH-UP] [CH-DN]

■EXITING THE ADJUSTMENT MODE

1 Turn the power OFF.

2 While pushing and holding and [CH-UP], turn ON. Never release [CH-UP] until 1 short beep sounds. 3 Push [CH-UP] button, then sounds 2 beep audio.

■AFTER FINISHING ADJUSTMENT

CAUTION!: When the adjustment is finished, the repeater need to be canceled adjustment mode. Otherwise the repeater does not work properly.

1Perform the step 1 to 4, described in the PROCESS TO PERMIT “ADJUSTMENT MODE ACCESS” (see page 4-2).

2 Click the “EXPERT 2” tag, then clear the check box for the “Adjustment Mode Access”. 3 Click “OK” button, then cloning with the original memory data.

22

3

4 - 3