Icom IC-FR3000 manual Preparation, Required Test Equipment, Battery RX, Mic

SECTION 4 ADJUSTMENT PROCEDURES

4-1 PREPARATION

Some adjustments must be performed on the “ADJUSTMENT MODE”. CS-FR3000 CLONING SOFTWARE, OPC-478 CLONING CABLE and OPC-592 ADAPTOR CABLE are required when entering the adjustment mode. Refer to the next page in detail.

■REQUIRED TEST EQUIPMENT

EQUIPMENT	GRADE AND RANGE		EQUIPMENT	GRADE AND RANGE
	Output voltage	: 13.6 V DC [FR3000]	Audio generator	Frequency range	: 300–3000 Hz
DC power supply		13.2 V DC [FR3100]		Output level	: 1–500 mV
	Current capacity	: 25 A or more
			Attenuator	Power attenuation	: 40 or 50 dB
	Measuring range	: 1–100 W		Capacity	: 100 W or more
RF power meter	Frequency range	: 100–300 MHz
				Frequency range	: 120–600 MHz
(terminated type)	Impedance	: 50 Ω	Standard signal
				Output level	: 0.1 µV–32 mV
	SWR	: Less than 1.2 : 1	generator (SSG)
					(–127 to –17 dBm)
	Frequency range	: 0.1–600 MHz
Frequency counter			AC millivoltmeter	Measuring range	: 10 mV–10 V
	Frequency accuracy	: ±1 ppm or better
	Sensitivity	: 100 mV or better	Oscilloscope	Frequency range	: DC–20 MHz
				Measuring range	: 0.01–20 V
FM deviation meter	Frequency range	: DC–600 MHz
			Digital multimeter		: 10 MΩ/V DC or better
	Measuring range	: 0 to ±5 kHz		Input impedance

•CONNECTION

Standard signal generator

–127 to –17 dBm

DC power supply

13.6V/25 A [FR3000]

13.2V/25 A [FR3100]

RF power meter 1–100 W / 50 Ω

Attenuator	FM deviation meter
40 dB or 50dB	(DC measurable)

Frequency counter

Oscilloscope

[BATTERY] [RX]

Personal computer

RS-232C connector

[MIC]

[TX]

Microphone connector		–
			Audio
		+
			generator
MIC GND	MIC INPUT		AC
1	8		millivoltmeter
	GND		PTT

JIG CABLE

OPC-478 + OPC-592

4 - 1