Icom IC-R8500 instruction manual SKIP p, AUTO p, PRIO p, DLY D/S p, @8KEYPAD

PANEL DESCRIPTION 1

		1 QZ	2 ABC	3 DEF	. ; ,
	OFF DLY ∞
					M-CH
		4 GHI	5 JKL	6 MNO	BANK
SEL-CH SKIP-CH	kHz				@8
		7 PRS	8 TUV	9 WXY	BANK
IC-R8500	M
					ENT
		.	0	CE	ENT
				NAME
		MEMO	PROG	AUTO	PRIO
			SCAN/ SCAN SET		@7
		SEL	SKIP	VSC	DLY D/S

M-SET BANK

M-CH DELAY/SPEED

M-CL MW

@1@2 @3 @4

@5 @6

grammed scan.

[SKIP] (p. 25)

➥Push momentarily to toggle the skip function ON and OFF for any scan.

•Automatic skip activation is available with the [MEMO] switch.

➥Push for 1 sec. to set the memory channel as a skip channel.

[AUTO] (p. 24)

➥Push momentarily to start/stop auto write scan.

➥Push for 1 sec. to select the written memories condition for the auto write scan.

•Two conditions are available, clear auto-written mem- ories before scan starts; and, keep auto written mem- ories before scan start.

[VSC] (p. 26)

Push to toggle the voice scan control function ON and OFF.

•The VSC function resumes the scan when a detected sig- nal does not contain voice components.

•“VSC” appears while the voice scan control function is activated.

[PRIO] (p. 25)

➥Push momentarily to start/stop priority scan.

•Priority scan can be used in combination with other scans.

➥Push for 1 sec. to enter the priority channel pro- gramming condition.

[DLY D/S ] (p. 27)

➥Push momentarily to select a scan resume condi- tion.

➧“OFF” is underscored: scan pauses on a signal until it disappears, then resumes 3 sec. after that.

➧“DLY” is underscored: scan resumes according to the

[DELAY/SPEED] control setting. When a signal dis-

➧“∞” is underscored: scan is cancelled when receiving a signal.

➥Push for 1 sec. to enter the delay time/scan speed setting condition.

•The function of the [DELAY/SPEED] control can be se- lected.appears, scan resumes 3 sec. later.

@8KEYPAD

The keypad can be used for several functions as below:

•Keypad then [ENT] (then [MW])

—Direct frequency input.

•Keypad then [M-CH]

—Memory channel selection.

•[CE • NAME] then keypad

—Alphanumeric input for memory, bank names, etc.

•Keypad then [TSY] or [TSZ]

—Arbitrary tuning step setting.

•Keypad then [MEMO] or [SEL]

—Specify memory bank then start memory scan or se- lect memory scan.

•Keypad then [PROG] or [AUTO]

—Specify scan edge group, then start programmed scan or auto write scan.

4