1 PANEL DESCRIPTION
■Rear panel
q w e r
!1
qRS-232C CONNECTOR (p. 10)
Connects an
wCI-V REMOTE CONTROL JACK (p. 10)
Allows connection to an Icom
CONVERTER.
eIF OUT JACK (p. 40)
Outputs a 10.7 MHz IF signal with 9 V DC for an op-
tional
rAGC JACK (pgs. 16, 40)
This jack has functions which are selectable through
internal receiver settings.
• Outputs an AGC signal for an optional
CEIVE ADAPTER (default).
•Outputs audio detected signal without
tDC 13.8 V JACK (p. 8)
➥Plug in the jumper connector here when using the supplied* AC adapter.
➥Connects to a 13.8 V DC power source using the supplied DC cable when the AC adapter is not connected.
*Not supplied with some versions.
yEXTERNAL SPEAKER JACK Connects an 8 Ω external speaker.
•When an external speaker is connected, the internal speaker does not function.
ty u
i
!0 o
uDC IN JACK (p. 8)
Connects the supplied* AC adapter.
•A regulator circuit has been designed between this con- nector and the DC 13.8 V jack.
•Be sure the jumper connector is connected to the DC
13.8 V jack.
*Not supplied with some versions.
iHF 50 Ω ANTENNA CONNECTOR (p. 8)
Connects an antenna to cover the frequency range below 30 MHz.
•Use a coaxial cable and a
•Be sure this connector is selected in quick set mode (p. 31).
oGROUND TERMINAL (p. 9) Connect this terminal to a ground.
!0HF 500 Ω ANTENNA CONNECTOR (p. 8)
When a 500 Ω long wire antenna is used for HF band receiving, this connector is used instead of the 50 Ω antenna connector.
•Set the “HF ANT” item to 500 to use this connector (p. 31).
!1VHF/UHF ANTENNA CONNECTOR (p. 8) Connects an antenna to cover the frequency range over 30 MHz.
• Use a coaxial cable and
5