ID Tech 80, 25, 60 Magnetic Stripe Selections, Read Two-Digit Addendum, Read Five-Digit Addendum

Read Two-Digit Addendum

If enabled, the reader will decode the two-digit secondary symbol when it is scanned with the primary symbol, and add the data to the end of the transmission. If not, any two-digit secondary symbol will be ignored.

G2<ENTER>I for Read Two-Digit Addendum

G2<ENTER>J for Do Not Read Two-Digit Addendum

Read Five-Digit Addendum

This option operates in the same manner as the Read Two Digit Addendum option except it enables the reading of a five digit second- ary symbol.

G2<ENTER>K for Read Five-Digit Addendum

G2<ENTER>L for Do Not Read Five-Digit Addendum

Addendum Required

If a two or five-digit addendum is enabled, then enabling this option will require an addendum be present before a good read is registered. If not, then symbols with and without the addendum will be accepted.

G2<ENTER>M for Addendum Required

G2<ENTER>N for Addendum Not Required

Add Separator Space

This option is used with the Two and Five-Digit Addendum options. If enabled, an ASCII space character is inserted between the data de- coded from the primary UPC symbol and the addendum symbol.

G2<ENTER>O to Add Space Separator

G2<ENTER>P to Not Add Space Separator

Magnetic Stripe Selections

The Omni reader can accept and decode data read from a magnetic stripe. The parameters for reading the magnetic data can be pro- grammed independently from any of the bar code selections.

1.Enter RETAIL BAR CODE SETUP MODE by typing /E/D/FH.

2.Press <ENTER>.

3.Type the one or two-character code for the selection you wish to make.

4.Save your selection by pressing <ENTER>.

5.To review the current setting, enter HY<ENTER>.

6.Exit the group setup mode by entering HZ<ENTER>.

7.To reset the terminal type setting to default, enter HX<ENTER>.

2 6 2 7