Appendix A
BAR CODE DEFAULT SETTINGS
The Omni reader is shipped from the factory with the following bar code default settings already programmed:
Terminal Selection |
|
Type | IBM PC/AT Keyboard |
General Selection |
|
Beep Volume | High |
Intercharacter Delay | 5 milliseconds |
Interblock Delay | 0 milliseconds |
Language | United States |
Code ID | Off |
Scan Verification | Off |
Automatic Verification | 01 |
Function Code | Off |
Message Formatting |
|
Terminator Character | CRLF |
Preamble | None |
Postamble | None |
Wand Emulation |
|
Emulation Mode | Code 39 |
Scan Rate | 10 inches per second |
Bar Code Polarity | Black = High |
Wide/Narrow Ratio | 2.5:1 |
Code 39 | Enabled |
Full ASCII | On |
Check Digit | Off |
Send Check Digit | No |
Send Start/Stop | No |
Minimum Length | 1 |
Maximum Length | 60 |
Interleaved 2 of 5 | Enabled |
Fixed Length | Off |
Check Digit | None |
Minimum Length | 4 |
Maximum Length | 60 |
Industrial 2 of 5 | Enabled |
Fixed Length | Off |
Check Digit | None |
Minimum Length | 1 |
Maximum Length | 60 |
Code 128 | Enabled |
Minimum Length | 1 |
Maximum Length | 60 |
Codabar | Enabled |
Send Start/Stop | No |
Check Digit | None |
Minimum Length | 2 |
Maximum Length | 60 |
MSI/Plessy | Enabled |
Send Check Digit(s) | No |
Check Digits | Modulo 10/Modulo 10 |
Minimum Length | 1 |
Maximum Length | 60 |
Code 93 | Enabled |
Minimum Length | 1 |
Maximum Length | 60 |
Code 11 | Enabled |
Check Digit(s) | 2 |
Send Check Digit(s) | No |
Minimum Length | 1 |
Maximum Length | 60 |
BC412 | Enabled |
Minimum Length | 1 |
Maximum Length | 60 |
Send Check Digit | Yes |
5 0 | 5 1 |
