Infortrend A16E-G2130-4 OFF, OFF, Lit, Temp, Green, Green, Amber, Amber, Amber, Green, Green, Green, Green, Green, C_Dirty, Hst Bsy, Drv Bsy, Restore, Default, BBU Link, Ctlr Status

EonStor A16E-G2130-4 Installation and Hardware Reference Manual

3.2.3 Controller Module LEDs

The LEDs on the rear-facing faceplate of the RAID controller are shown in Figure 3-2. The LEDs on the controller’s faceplate that can be accessed from the rear of the enclosure are numbered from 1 to 6. The definitions are shown below.

Figure 3-2: Controller Module LEDs

Name	Color				Status
		Green indicates that the RAID subsystem is
	Green/	operating healthily.
Ctlr Status		Amber indicates			that a	component		failure
	Amber
		has occurred, or inappropriate RAID
		configurations have caused system faults.
		ON indicates that there are certain amounts
C_Dirty	Amber	of cached data held in memory.
		OFF indicates that the cache is clean.
		ON	indicates		that	the	detected
		CPU/board/chassis temperature has exceeded
Temp.	Amber	the higher temperature threshold.
		OFF indicates that the detected temperature
		reading is within the preset safe range.
BBU Link	Green	ON indicates the presence of a BBU backup
		module.
Hst Bsy	Green	Rapidly Blinking to indicate traffic on the
		host bus.
Drv Bsy	Green	Rapidly Blinking to indicate traffic on the
		drive channels.
Restore	Green	Lit	Green	to	indicate		the	RAID
		configuration		default has		been	successfully
Default
		restored. The LED state will be invalidated

3-4 Status-indicating LEDs