Insignia NS-42 24

				Insignia NS-42LCD 42-inch LCD TV
Memorizing channels			If TV Source is set to CABLE, highlight Auto
	When you turn on the TV for the first time, you		Search, then press or . The Channel
	When you turn on the TV for the first time, you		Scan Source window opens.Press or to
	should perform an auto channel search to set up		Scan Source window opens.Press or to
	should perform an auto channel search to set up		select STD (the most common type of
	stations on your TV. Before you perform an auto		select STD (the most common type of
	stations on your TV. Before you perform an auto		Cable TV), HRC, or IRC, then press OK to
	search, you should select the correct TV source.		Cable TV), HRC, or IRC, then press OK to
	search, you should select the correct TV source.		begin the auto channel search. The TV
			begin the auto channel search. The TV
Selecting the TV source			begins searching for all available CATV or
	Before your TV can memorize the available		CADTV channels.
	Before your TV can memorize the available
	channels, you must specify the type of signal
	channels, you must specify the type of signal
	source that is connected to the TV. (For
	example, an antenna or cable system.)
	To select a source:
	1 In single window status (with no
		picture-in-picture setting active), press MENU
		to display the Main Menu.

Note

If a picture-in-picture mode is active, your TV cannot do an auto search.

Note

If you want to stop the auto search, press MENU.

2Press or to display the CHANNEL SETUP menu page, then press to enter the menu.

3Press or to select TV Source, then press or to select AIR or CABLE.

•Select AIR if using an antenna.

•Select CABLE if using Cable TV.

Auto channel search

You should perform an auto search to search for available broadcast and cable/set-top box channels. After the TV finishes searching for channels, the TV stores the valid channels in memory.

•If TV Source is set to AIR, highlight Auto Search, then press or . The TV begins searching for all available TV or DTV channels.

Skipping channels

After saving channels into memory, you can skip unnecessary channels so that only the channels you want to watch are selected with the CH+/- buttons.

To skip channels:

1Open the CHANNEL SETUP menu.

2Highlight Current Channel, then press or to select an unwanted channel.

3Highlight Channel Skip, then press or to change the setting to ON.

4If you want to skip other unwanted channels, repeat Steps 2-3.

5Press EXIT to exit. The channels you specified will be skipped the next time you press the CH+/- buttons.

	- OR -
24	www.insignia-products.com