![](/images/new-backgrounds/1313327/31332793x1.webp)
Symptom | Possible cause | Remedy | |
|
|
| |
| JPEG files without a “.jpg” or “.JPG” or |
| |
| “.JPEG” filename extension are not recog- | Use the correct filename extension (page 8). | |
| nized. |
| |
|
|
| |
| Only Baseline JPEG files are supported. | Use Baseline JPEG files (page 8). | |
| Progressive JPEG files are not. | ||
Can’t view JPEG files? |
| ||
|
| ||
Only JPEG files with the following bright- |
| ||
|
| ||
| ness/color difference ratios are supported: | Use JPEG files with the supported ratio (page 8). | |
| 4:4:4, 4:2:2, and 4:1:1. |
| |
|
|
| |
| The JPEG file is too big. | Use JPEG files that are less than 5 megabytes | |
| (page 8). | ||
|
| ||
|
|
| |
The message “NO |
|
| |
PLAY” appears on the | The disc is dirty. | Remove the disc and clean it (page 8). | |
display? |
|
| |
|
|
| |
Buttons on the | Power supply voltage fluctuations and other | Turn off the | |
it on again. If that doesn’t resolve the issue, dis- | |||
and remote controller | anomalies, such as static electricity, can | ||
connect the power cord from the wall outlet, wait | |||
don’t work? | interfere with normal operation. | ||
five seconds, reconnect it, then try again. | |||
|
| ||
|
|
| |
| There are no batteries in the remote | Install new batteries (page 15). | |
| controller. | ||
|
| ||
|
|
| |
| The batteries are flat. | Replace with new batteries (page 15). | |
|
|
| |
| The batteries are installed incorrectly. | Check the batteries and correct as necessary | |
| (page 15). | ||
|
| ||
|
|
| |
| You’re not pointing the remote controller at | Point the remote controller at the | |
Buttons on the | the | remote sensor (page 15). | |
work OK but those on |
|
| |
| Use the remote controller closer to the | ||
the remote controller |
| ||
You’re too far away from the | (page 15). The remote controller has a range of | ||
don’t? | |||
| approximately 16 ft. (5 meters). | ||
|
| ||
|
|
| |
| A strong light source is interfering with the | Make sure that the | |
| direct sunshine or | ||
| |||
| Relocate if necessary. | ||
|
| ||
|
|
| |
| If the |
| |
| colored glass doors, the remote controller | Open the doors, or use a cabinet without colored | |
| may not work reliably when the doors are | glass. | |
| closed. |
| |
|
|
|
■Abnormal Behavior
The ] button until “RESET” appears on the display (about 10 seconds).
■Restoring the Default Settings
To reset the ] button, press the [Standby/On] button. “INITIALIZE” appears on the display. When the reset is complete, “COMPLETE” is displayed, and the
47