Integra DSR-7.3 instruction manual Connecting an FM Outdoor Antenna, Directional Iinkage

Connecting an FM Outdoor Antenna

If the FM reception is not very clear with the supplied antenna, connect an FM outdoor antenna instead of the indoor FM antenna .

Connecting coaxial cable to a 75/300 ohm antenna adapter (not supplied)

FM outdoor antenna

1Strip the end of the coaxial cable.

15 mm

6 3 6

mm mm mm

1/4 1/8 1/4

in. in. in.

5/8 in.

2With your fingernail or a small screwdriver, press the stoppers outward and remove the cover.

3Remove the transformer wire A from slit B and insert it into slit C.

Slit B

Wire A

Slit C

4Insert the end of the cable.

5 Clamp it in place with pliers.

4

5

	ANTENNA
AM	FM 75

Connecting 300 ohm ribbon wire to a 75/300 ohm antenna adapter*

Loosen the screws and wrap the wire around these screws. Then tighten the screws with a screwdriver.

Tighten

Loosen

6Reinstall the cover.

Notes

•Install the antenna well away from tall buildings and in an area where FM stations can directly be received.

•Keep the antenna away from noise sources (neon signs, busy roads, etc.).

•It is dangerous to put the antenna close to power lines. Keep it well away from power lines, transformers, etc.

•To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the “Important Safety Instructions” on page 2 when you install the outdoor antenna.

Directional Iinkage

Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter.

Directional linkage type splitter

To DVD Receiver To TV (or VCR)

23