Integra DSR-7.3 instruction manual Playing the Connected Source, About digital sound

Playing the Connected Source

This section shows you how to play the sources connected to the DVD Receiver.

You may need to see “Connecting to a TV” on pages 16 and “Connecting to Audio/Video Equipment” on page 19 while following the steps in this section.

Input Selector 2/3

Input 2/3

		Sen d
			S
se		On	tandby
n/Clo
Ope					Light
		Input	l
			Se ector		2
		Mode
		Recvr	Tape
DVD					TV
	Dimmer		Display
ep					Clo
Sle					ck
		Menu	Men	u
	Top
Step/Slow
CH		ENTER			VOL
Tun
	R	eturn	etup t
T-D/ST			TSVInpu		Muting
Surround			A.Control
Repeat					A-B
Late Night					Timer
Audio		Angle	Subtitle		FM Mode
Last M	Program		Random		Clear
SP Setup		Test Tone			CH Sel
1			2		3
SW Mode		Distance
4			5		6
IPM		T-D Setup Up/Down

Preset Memory

7	8	9
+10	0	Search
-- / ---		Enter

RC-507M

1 controllerRemote

Input Selector

Unit

Press Input Selector 2/3 on the remote controller or Input 2/3 on the unit to select one of the following input sources:

•TV

•TAPE/MD/CDR

The selected input source appears in the multipurpose display. Also the input source indicator is lit in the display until the DVD Receiver is switched to another input source.

e.g. When TAPE is selected.

About digital sound

If the equipment is digitally connected to the DVD Receiver, the sound from the digital input will automatically be selected and reproduced instead of the analog sound as explained below.

•When the TV source is selected, the digital sound from the DIGITAL OPTICAL INPUT jack is reproduced.

When the digital sound is reproduced, the DIGITAL indicator lights up in the display. According to the received sound system, the ŸDIGITAL or DTS indicator lights up.

ŸDIGITAL DTS

2 Start playing the selected source.

Changing the “TAPE” display to match the connected source

1Press the Input 2/3 button on the unit to select TAPE.

2Press the Preset Memory button. “NAME SEL” is displayed then “TAPE” flashes in the display.

3Press the Input 2/3 button repeatedly to select the desired operation.

The display changes as follows:

TAPE→MD→CDR→TAPE

4Press the Preset Memory button to select. “COMPLETE” appears then the display switches back to the selected input.

Note

The DVD Receiver only reproduces DOLBY DIGITAL, DTS, and PCM sound formats from connected equipment.

Various Functions While Playing the Connected Source

To use the following functions, see page 40.

•Adjusting the Volume

•Muting the Sound

•Listening Through Headphones

•Controlling the Brightness of the display on the DVD Receiver

Enjoying the Sound Effects While Playing the Connected Source

See page 46.

38