Integra DSR-7.3 instruction manual Setting the Clock Display

Connecting the Power/ Turning on the DVD Receiver

Before connecting

•Make sure that all the connections from pages 16 to 23 are complete (the connection to the TV is required).

•Turning on the DVD Receiver may cause a momentary power surge, which might interfere with other electrical equipment such as computers. If this happens, use a wall outlet on a different circuit.

Standby/On
On indicator
Standby indicator	Display

1	Connect the power cord to the AC
	INLET of the DVD Receiver.

AC INLET

■Setting the Clock Display

To display the clock while in Standby mode, hold down the Standby/On button for at least 2 seconds while the unit is in On mode.

Note

Displaying the clock in Standby mode consumes the same amount of

power as in the On mode.

2	Connect the power cord to a wall
	outlet.
	The DVD Receiver enters the standby
	mode and the Standby indicator lights up.
	AC INLET
	to wall outlet
3 Unit	Press Standby/On on the DVD
	Receiver or On on the remote
	controller to turn on the DVD
	Receiver.
	The light and display on the DVD
	Receiver’s front panel light. At the same
	time, the Standby indicator goes off and
	the On indicator lights up.

Remote Controller

On

On indicator

Standby indicator

•To put the DVD Receiver in the standby mode, press Standby/On on the DVD Receiver, or Standby on the remote controller. Be sure to set the volume to minimum before putting the DVD Receiver in the standby mode for the next use to avoid sudden loud sound reproduction.

•While in the Standby mode, the DVD Receiver can receive signals from the remote controller.

•Setting the Standby button on the Remote controller to standby does not shut off the power completely.

24