Integra DTR-7.1 Connecting to the IR IN MAIN input, Connecting to the remote zone Zone 2 input

Connecting to the remote zone (Zone 2) input

When using the ZONE 2 OUT terminals

The ZONE 2 OUT terminal is a constant output. Connect to the LINE input of the amplifier (CD, tape, etc.). Adjust the volume with the amplifier connected to the ZONE 2 OUT terminal.

1.Connect the DTR-7.1 to the amplifier for the remote zone.

2.Connect the remot zone speaker cables to the speaker terminals on the amplifier.

3.Install the connecting block in the main zone and connect it to the IR IN ZONE 2 input at the DTR-7.1.

4.Install the remote sensor in the remote zone and connect it to the connecting block in the main zone.

Connection example for Onkyo’s Multi-room System kit

Wall outlet Power supply Main zone Remote zone (Zone 2)

Mini plug cable	Connecting block	Remote controller
	Remote sensor
ZONE 2	MAIN
	IR IN

							Zone 2	Zone 2
							speaker	speaker
			ANTENNA	COMPONENT	RS 232	L FRONT
				VIDEO	R
			12 V			SPEAKERS
		PRE
		OUT	TRIGGER	INPUT 1			AC OUTLETS
		FRONT		IR IN		CENTER
					SURR	SPEAKER
		SURR			BACK
					SPEAKER
	GND	SURR	VIDEO		R	L
		BACK	1
		SUB	CENTER			SURR
		WOOFER		INPUT 2
						SPEAKERS
			VIDEO		MAIN		CAUTION:
FRONT			2		R	L	SPEAKER IMPEDANCE
						ZONE 2
		TAPE	VIDEO3			SPEAKERS
SURR					ZONE 2
						AC INLET
				OUTPUT
SURR		CD	DVD		MODEL NO. DTR-7.1
BACK
SUB		PH
WOOFER
MULTI CHANNEL	CENTER		ZONE 2	MONITOR
INPUT			OUT	OUT
						DTR-7.1
			ZONE 2				Zone 2 amplifier
			OUT

RL

LINE input

Signal flow

Connecting to the IR IN MAIN input

Outline

If the DTR-7.1 is located inside a cabinet or other enclosure where the infrared beams from the remote controller cannot enter, then operation with the remote controller will not be possible. In such a case, it will be necessary to install a remote sensor at a location outside of the cabinet for the infrared beams from the controller to reach.

Power supply Wall outlet

Connecting block

1.Connect the connecting block to the IR IN MAIN input at the DTR-7.1.

2.Install the remote sensor at a location where it can detect the infrared beams from the remote controller.

3.Connect the remote sensor to the connecting block.

Mini plug cable			Remote sensor	Remote controller
DTR-7.1			Outside of the cabinet
ANTENNA		AM	FM
			75
12 V
TRIGGER
B	A	ZONE 2	MAIN
			IR IN
R		L
			In the cabinet	25