Integra DTR-7.1 appendix Using a Macro function, Macro mode programming memo

Using a Macro function

ON STNBY

AUDIO			MUTING
TRACK		DISC
REC			OPEN/CLOSE
DVD			CD
T1	T2	TUN	PH
V1	V2	V3	V–
STEREO		DIRECT	DSP
1		2	3
SURROUND		THX	DSP
4		5	6
Re-EQ		CH SEL	LEVEL +
7		8	9
LATE NIGHT DIMMER			LEVEL –	ENT
+ 10		0	ENT

HOME THEATER CONTROLLER

RC-418M

Macro mode programming memo:

Erasing all commands and macros that have been programmed

This procedure will erase all the commands and macros that you have programmed into the remote controller and return it to its default settings. This operation will not affect the preset settings of the remote controller.

1.Open the battery cover and remove the batteries from the remote controller.

2.While pressing and holding down the ON and STNBY buttons, re-insert the batteries in their correct orientation, and then release both buttons.

The SEND/LEARN indicator flashes slowly and “CLEAR” appears in the display.

3.Press the ENT button.

The SEND/LEARN indicator lights up for about ten seconds and then turns off and “AUDIO” appears in the display.

All programmed commands and macros are erased and the remote controller returns to its factory presets.

Notes:

•Proceed to Step 3 immediately after Step 2; otherwise, the batteries will be consumed quickly.

•If you press any button other than the ENT button in Step 3, nothing will be erased. In this case, resume from Step 1.

MACRO	MODE	MODE	MODE	MODE	MODE	MODE	MODE	MODE	DIRECT
	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO
	↓	↓	↓	↓	↓	↓	↓	↓
	AUDIO	CD	DVD	MD	SAT	CABLE	VCR	TV
Operation 1
Operation 2
Operation 3
Operation 4
Operation 5
Operation 6
Operation 7
Operation 8
Operation 9
Operation 10
Operation 11
Operation 12
Operation 13
Operation 14
Operation 15
Operation 16

67