Integra DTR-8.8 instruction manual First Time Setup, Speaker Settings

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

Speaker Settings

	Game/TV	AUX 1			AUX 2				TV CH
If you change these settings,							you must run the auto-
	4		5			6			-
	Tape	Tuner			CD
matic speaker setup again (see page 55).
	7		8			9
	Phono	Net/USB			D.TUN				TV VOL
	+10		0		Clear
	--/--- 10			11				12
	Input Selector
		Macro
	1		2			3			Zone3
		Remote Mode
	DVD	VCR			CD				Zone2
				CDR/MD/Dock						1
	TV	Cable			Net/USB				Receiver
		SAT							Tape/AMP
	Dimmer								Sleep
2, 3				nu	Me					2–5
			Me
		op					nu
		T
	+
	CH			Enter					VOL
	Disc
	Album
1, 6	-		G
						it
	Prev		uide		Ex
		Se		p	R			n
	CH		tu			ur
					et
	Display								Muting
	Rec			Playlist					Random

If the impedance of any speaker is 4 ohms or more but less than 6, set the Speaker Impedance to 4 ohms.

To use bi-amping or bridging, you must change the Speaker Type setting. For hookup information, see pages 25 and 26.

Notes:

•When bi-amping is used, the AV receiver is able to feed up to 5.1 speakers in the main room.

•When bridging is used, the AV receiver is able to drive up to 2.1 speakers in the main room.

•Before you change these settings, turn down the vol- ume.

The onscreen menus shown in this manual may be slightly different from what you see on your TV.

1	Press the [Receiver] button, fol-
Receiver	lowed by the [Setup] button.
	The main menu appears onscreen.
S
et
u
p
2	Use the Up and Down [ ]/[ ]
	buttons to select “2. Speaker
Enter	Setup,” and then press [Enter].
	The Speaker Setup menu appears.

3	Use the Up and Down [	]/[ ]
	buttons to select “1. Speaker Set-
	tings,” and then press [Enter].
	Enter
	The Speaker Settings menu appears.
	2-1.Speaker Settings
	Speaker Impedance	6ohms
	Speakers Type	Normal
	Enter

4	Use the Up and Down [ ]/[ ]
	buttons to select “Speaker

Impedance,” and use the Left and

Enter

Right []/[ ] buttons to select:

4 ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6.

6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms.

5	Use the Up and Down [ ]/[ ]
	buttons to select “Speaker Type,”

and use the Left and Right

Enter

[]/[ ] buttons to select:

Normal: Select this if you’ve con- nected your front speakers normally.

Bi-Amp:Select this if you’ve con- nected your front speakers for bi-amped operation.

BTL: Select this if you’ve con- nected your front speakers for bridged operation. The BTL indicator will appear on the display.

6	Press the [Setup] button.
	Setup closes.
	S
	et
	u
	p

Note:

•This procedure can also be performed on the AV receiver by using its [Setup], [Enter], and arrow but-

tons.

Enter

47