Intel Desktop Board D925XCV/D925XBC Technical Product Specification
Resume on Ring enables telephony devices to access the computer when it is in a
✏NOTE
The use of Resume on Ring and Wake from USB technologies from an ACPI state requires an operating system that provides full ACPI support.
1.14.2.1Power Connector
When resuming from an AC power failure, the computer returns to the power state it was in before power was interrupted (on or off). The computer’s response can be set using the Last Power State feature in the BIOS Setup program’s Boot menu.
For information about | Refer to |
The location of the power connector | Figure 21, page 68 |
|
|
The signal names of the power connector | Table 29, page 75 |
|
|
1.14.2.2Fan Connectors
The function/operation of the fan connectors is as follows:
•The fans are on when the board is in the S0 or S1 state.
•The fans are off when the board is off or in the S3, S4, or S5 state.
•Each fan connector is wired to a fan tachometer input of the hardware monitoring and fan control ASIC
•All fan connectors support
•All fan connectors have a +12 V DC connection
For information about | Refer to |
The location of the fan connectors | Figure 21, page 68 |
|
|
The location of the fan connectors and sensors for thermal monitoring | Figure 15, page 38 |
|
|
The signal names of the fan connectors | Section 2.8.1.1, page 64 |
|
|
1.14.2.3LAN Wake Capabilities
CAUTION
For LAN wake capabilities, the +5 V standby line for the power supply must be capable of providing adequate +5 V standby current. Failure to provide adequate standby current when implementing LAN wake capabilities can damage the power supply.
LAN wake capabilities enable remote
44