Place Battery Marking on Computer
There is insufficient space on this server board to provide instructions for replacing and disposing of the battery. The following warning must be placed permanently and legibly on the host computer as near as possible to the battery.
WARNING
Danger of explosion if battery is incorrectly replaced.
Replace with only the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.
Use Only for Intended Applications
This product was evaluated for use in ITE computers that will be installed in offices, schools, computer rooms and similar locations. The suitability of this product for other product categories other than ITE applications, (such as medical, industrial, alarm systems, and test equipment) may require further evaluation.
Installation Precautions
When you install and test the server board, observe all warnings and cautions in the installation instructions.
To avoid injury, be careful of:
∙Sharp pins on connectors
∙Sharp pins on printed circuit assemblies
∙Rough edges and sharp corners on the chassis
∙Hot components (like processors, voltage regulators, and heat sinks)
∙Damage to wires that could cause a short circuit
Observe all warnings and cautions that instruct you to refer computer servicing to qualified technical personnel.
WARNING
Do not open the power supply. Risk of electric shock and burns from high voltage and rapid overheating. Refer servicing of the power supply to qualified technical personnel.
108 | Regulatory and Integration Information |