Recovering the BIOS

It is unlikely that anything will interrupt the BIOS upgrade; however, if an interruption occurs, the BIOS could be damaged. The following steps explain how to recover the BIOS if an upgrade fails. The following procedure use recovery mode for the Setup program.

/NOTE

Because of the small amount of code available in the nonerasable boot block area, there is no video support. You will not see anything on the screen during the procedure. Monitor the procedure by listening to the speaker and looking at the floppy drive LED.

1.Turn off all peripheral devices connected to the computer. Turn off the computer.

2.Remove the computer cover.

3.Locate jumper block J3J2.

4.Move the Recovery Boot jumper from pins 9-10 to pins 10-11 (see Figure 17 on page 99).

5.Insert the bootable BIOS upgrade floppy disk into floppy drive A.

6.Replace the cover, turn on the computer, and allow it to boot. The recovery process will take a few minutes.

7.Listen to the speaker.

8.Two beeps and the end of activity in drive A indicate successful BIOS recovery.

9.A series of continuous beeps indicates failed BIOS recovery.

10.If recovery fails, return to step 1 and repeat the recovery process.

11.If recovery is successful, turn off the computer. Remove the computer cover and continue with the following steps.

12.Move the Recovery Boot jumper back to pins 9-10.

13.Replace the computer cover. Leave the upgrade disk in drive A and turn on the computer.

14.Continue with the BIOS upgrade (see page 80).

Changing the BIOS Language

You can use the BIOS upgrade utility to change the language the BIOS uses for messages and the Setup program. Use a bootable floppy disk containing the Intel flash utility and language files.

1.Boot the computer with the bootable floppy disk in drive A. The BIOS upgrade utility screen appears.

2.Select Update Flash Memory From a File.

3.Select Update Language Set. Press <Enter>.

4.Select drive A and use the arrow keys to select the correct .lng file. Press <Enter>.

5.When the utility asks for confirmation that you want to flash the new language into memory, select Continue with Programming. Press <Enter>.

6.When the utility displays the message upgrade is complete, remove the floppy disk. Press

<Enter>.

7. The computer will reboot and the changes will take effect.

L440GX+ Server Board Product Guide

81