3 Configuration Software and Utilities
This chapter describes the Power On Self Test (POST) and server configuration utilities. The table below briefly describes the utilities.
Table 4. | Configuration Utilities |
| |
Utility |
| Description and brief procedure | Page |
|
|
|
|
BIOS Setup |
| If the system does not have a diskette drive, or the drive is disabled or | 35 |
|
| misconfigured, use Setup to enable it. |
|
|
| Or, you can move the CMOS jumper on the server board from the default |
|
|
| setting (Protect CMOS memory) to the Clear setting; this will allow most server |
|
|
| configurations to boot. For the procedure to do this, see the section “CMOS |
|
|
| Jumper” in Chapter 5 in this manual. Then run the SSU to configure the |
|
|
| server. |
|
|
|
| |
System Setup | Use for extended system configuration of onboard resources and | 50 | |
Utility (SSU) | boards, and for viewing the system event log, setting boot device priority, or |
| |
|
| setting system security options. |
|
|
| The SSU may be run from either the Server Configuration CD or from a DOS- |
|
|
| bootable diskette. |
|
|
| Information entered via the SSU overrides information entered via BIOS |
|
|
| Setup. |
|
|
|
| |
EMP Console | Use to access and monitor the server remotely. | 62 | |
|
|
| |
FRUSDR Load | Use to update the Field Replacement Unit (FRU), Sensor Data Record (SDR), | 75 | |
Utility |
| and Desktop Management Interface (DMI) flash components. |
|
|
|
| |
BIOS Update | Use to update the BIOS or recover from a corrupted BIOS update. | 79 | |
Utility |
|
|
|
|
|
| |
Firmware Update | Use to update BMC flash ROM. | 82 | |
Utility |
|
|
|
|
|
| |
Using the Adaptec | Use to configure or view the settings of the SCSI host adapters and onboard | 83 | |
SCSI Utility |
| SCSI devices in the server. |
|
|
|
|
|
Hot Keys
Use the keyboard’s numeric pad to enter numbers and symbols.
Table 5. | Hot Keys |
|
To do this: |
| Press these keys |
|
| |
Clear memory and reload the operating | <Ctrl+Alt+Del> | |
system⎯this is a system reset. |
| |
|
| |
Secure your system immediately. | <Ctrl+Alt>+hotkey (Set your hot key combination with the | |
|
| SSU or Setup.) |
|
|
|
33