Verifying the Installation

After you have installed the ITI-8241C-S combination adapter, but before you boot the system, perform the following tasks to verify the installation.

Power on the system and when the banner appears, press the Stop-A keys to interrupt the boot process and to get to the ok prompt.

1.Use the show-devscommand to list the system devices.

You should see lines in the list of devices, similar to the example below. Ports identified as “/pci@1f,2000/pci@2/IntraServer,qfe@0,1” are the IntraServer fast Ethernet ports on the ITI-8241C-S adapter.

Your system will vary significantly from the example below depending on your system configuration.

ok show-devs

…

/pci@1f,2000/pci@2/IntraServer,qfe@0,1

/pci@1f,2000/pci@2/IntraServer,qfe@1,1

/pci@1f,2000/pci@2/IntraServer,qfe@2,1

/pci@1f,2000/pci@2/IntraServer,qfe@3,1

…

Note: If you do not see the devices listed, check to see that the adapter is firmly seated in the PCI slot. Remove and reinstall the adapter if necessary

Page 44 of 83