Manuals / Invacare / Lawn and Garden / Hot Tub

Invacare 3800, 3750 manual Operation, Overview

Models: 3750 3800

1 36

Download 36 pages 1.41 Kb

Page 22

Image 22

SECTION 3—OPERATION

Overview

The tub is designed to improve the efficiency and environmental safety of your facilityʹs operation. However, if the tub is not operated or maintained properly, the benefits designed into the system will not be realized. The purpose of this manual is to provide you with recommended procedures to help you obtain the maximum efficiency and safety while using your tub.

When using the tub, perform these steps in the following order:

1.Make sure the tub has been disinfected before use.

2.Open the tub door.

3.Transfer the resident into the tub.

4.Bathe the resident.

5.Transfer the resident from the tub.

6.Disinfect the tub, including the door seal.

Recessed Side Entry Bath Tubs

Part No 1150695

Page 22

Image 22

Invacare 3800, 3750 manual Operation, Overview

Contents

Model Model Owner’s Operation and Maintenance ManualRecessed Side Entry Bath Tubs DEALER This manual MUST be given to the user of the tubCustomer Service ‐ 1‐800‐668‐2337 Technical Support ‐ 1‐800‐668‐2337 ACCESSORIES WARNINGFor further information on this product, please call the following FEATURES TABLE OF CONTENTSTABLE OF CONTENTS SECTION 2-PARTS AND INSTALLATIONRemoving Soap Film and Hard Water Deposits TABLE OF CONTENTSTABLE OF CONTENTS Removing Calcium Deposits, Scale and Lime Build-upSPECIAL NOTES LABEL LOCATION LABEL LOCATIONRecessed Side Entry Bath Tubs TYPICAL PRODUCT PARAMETERS TYPICAL PRODUCT PARAMETERS3750 FEATURESFEATURES Shower ONShower ON 3800FEATURES WhirlpoolSECTION 1-GENERAL GUIDELINES Important Safety InstructionsInstallation DANGERDANGER ElectricalPlumbing GroundingDisinfecting Maintenance and InspectionDANGER Operation DANGERNOTE For this procedure, refer to FIGURE SECTION 2-PARTS AND INSTALLATIONAbout Installation Parts InformationInstalling the Tub NOTE Follow recommended floor plan when installing tub FIGUREB. Plumb the supply line to the diverted output port of the mix valve NOTE Model 3750 shown NOTE For this procedure, refer to FIGURE 2.5 on pageElectrical and Plumbing Hook-up Locations on the Tub FIGURE 2.5 Electrical and Plumbing Hook-up Locations on the TubNOTE Use 15 AMP GFCI breaker only Electrical InstallationNOTE For this procedure, refer to FIGURE 2.6 on page DANGER8. Remove the motor cover Detail “C” Plumbing Installation DANGERPost Installation Checklist SECTION 3-OPERATION OverviewDisinfecting the Tub Using the Closed Loop System SECTION 3-OPERATIONTub Operation NOTE For this procedure, refer to FIGURE 3.1 on pageOpening/Closing the Tub Door Opening the Tub DoorFlow Water Thermometer Water Temperature Valve Water Temperature SettingNOTE For this procedure, refer to FIGURE DANGEROperating Shower/Massage Wand NOTE Refer to following chart for shower head adjustment settingsNOTE For this procedure, refer to FIGURE 3.4 on page Filling TubNOTE For this procedure, refer to FIGURE HydromassageFIGURE 3.4 Filling Tub Drain Plug Drain FIGURE 3.5 HydromassageSECTION 3-OPERATION Whirlpool On/Off ButtonInitially SECTION 4-MAINTENANCESafety Inspection Checklists Before Each UseCleaning Your Tub Maintenance OverviewCleaning the Door Seal Gasket Removing Soap Film and Hard Water DepositsHeavy Duty Cleaning Procedure SECTION 4-MAINTENANCENOTE Equipment needed Bucket or Pail, at least 1 Gallon NOTE For this procedure, refer to FIGURE 4.1 on pageCalibrating the Disinfectant Flow Meter Graduated plastic bottle, at least 16 ounces Felt Tip PenNOTE Liquid will be heard filling the interior plumbing of the tub 13. Turn the disinfectant valve to the on positionTYPE OF MAINTENANCE PERFORMED Maintenance RecordMAINTENANCE PERSON DATESYMPTOMS SECTION 5-TROUBLESHOOTINGSECTION 5-TROUBLESHOOTING FAULTSLIMITED WARRANTY Canada