Operating Shower/Massage Wand, Filling Tub

SECTION 3—OPERATION

Operating Shower/Massage Wand

NOTE: For this procedure, refer to FIGURE 3.3.

NOTE: STEPS 1 ‐ 3 are to be performed while holding the shower/massage wand over the tub.

1.Turn shower/massage wand on to desired flow by rotating shower On/Off valve (Detail “A”).

2.Adjust water temperature using the water temperature valve while watching the flow water thermometer (Detail “B”).

3.Adjust shower spray by rotating shower wand head (Detail “C”).

NOTE: Refer to following chart for shower head adjustment settings.

Stream

Shower Spray

Mixture of Spray and Pulse Massage

Pulse Massage

DETAIL “A”

DETAIL “B”

DETAIL “C”

Flow Water

Thermometer

Shower/Massage

Wand

Head

Shower On/Off Valve	Water Temperature Valve

NOTE: For this procedure, refer to FIGURE 3.4 on page 27.

1.Close the drain (Detail “A”).

2.Turn tub fill On/Off valve to On position by rotating valve (Detail “B”).

3.Adjust water temperature using the water temperature valve while watching flow water thermometer (Detail “C”).

4.Turn tub fill on/off valve to off position when water reaches desired level (Detail “B”).

NOTE: If hydromassage use is anticipated, water level MUST be completely above the whirlpool jets (Detail “A”).

Recessed Side Entry Bath Tubs

Part No 1150695