Invacare 3750 Troubleshooting, Symptoms, Faults, Solution, Disinfecting System, Tub Operation

SECTION 5—TROUBLESHOOTING

SECTION 5—TROUBLESHOOTING

SYSTEM/OPERATION	SYMPTOMS	FAULTS	SOLUTION
Hydromassage System	System will not start	No electrical power to tub	Check and reset breaker or
			GFCI.
		System not prepared	Be sure water level is above jets.
			Check that inlet plug on tub is
			depressed.
		Switch hose disconnected	Reconnect hose to switch and
			motor.
	System is ineffective	Water deposits in	Disassemble and clean whirlpool
		whirlpool jets	jets.
		Whirlpool jets closed	Open whirlpool jets.
		Aerator closed	Open aerator.
		Whirlpool intake clogged	Inspect intake and remove
			obstruction.
Disinfecting System	No discharge from	Whirlpool jets open	Close whirlpool jets.
	disinfectant wand
		Whirlpool intake open	Close whirlpool intake.
		Hose kinked	Inspect hose and unkink.
		Disinfectant siphon tube	Inspect siphon tube and unkink.
		kinked
		Flow meter adjustment	Turn flow meter adjustment knob
		knob turned off	to proper setting.
Tub Operation	No water flow	Water supply turned off	Turn on water supply.
	Restricted water flow	RADA valve. Refer to	Inspect and clean RADA valve.
		RADA owner’s manual.

NOTE: If problems are not remedied by the suggested means above, contact an ICCG dealer or technical support.

Part No 1150695 35 Recessed Side Entry Bath Tubs