Invacare R51LXP, R50LX manual Display Description Definition

SECTION 5—WHEELCHAIR OPERATION

The Information Gauge display also serves as a system diagnostic device when a fault is detected by the control module. A specific number of flashes of the LEDs indicates the type of fault detected. Refer to the following table of the diagnostic indications of the wheelchair status.

DISPLAY	DESCRIPTION	DEFINITION	COMMENTS
	All three (3) LEDs are off.	Power is Off.
INVACARE

All three (3) LEDs are on. Power is On.	Fewer than three (3)
	LEDs on implies reduced
	battery charge.

INVACARE

RED LED is flashing.	Battery charge is low.	The batteries should be
		charged as soon as possi-
		ble.

INVACARE

Left to Right “chase” alter-	Joystick is in program-	The steady LEDs indicate
nating with steady display.	ming, inhibit and/or charg-	the current state of the
	ing mode.	battery charge.

INVACARE

GREEN LED is flashing.	Joystick is in Speed Limit	The current state of bat-
	mode.	tery charge will be dis-
		played at the same time.

INVACARE

All LEDs are flashing slowly. Joystick has detected	Release the joystick back
Out-of-Neu-	to Neutral.
tral-at-Power-Up mode.

INVACARE

All LEDs are flashing quickly.

Joystick has detected a fault.

Joystick uses Flash codes to indicate faults.

INVACARE

Part No.1106645 30 Nutron® Series