Invacare R50LX, R51LXP manual Changing the Back Angle

SECTION 8—BACK

Using the Fold Down Back Canes (R51, 51LX and R51LXP Models Only)

WARNING

The back MUST be locked securely in place before using the wheelchair.

NOTE: For this procedure, refer to FIGURE 8.2.

1.Perform one (1) of the following:

•Unfold ‐ Push/pull the back toward rear of wheelchair until it locks in place.

•Fold ‐ Pull up on the back release latches and push the back toward the front of the wheelchair.

Back Locked

Securely

Back Cane

Front of

Wheelchair

Back

Release

Latch

FIGURE 8.2 Using the Fold Down Back Canes (R51, 51LX and R51LXP Models Only)

Changing the Back Angle

NOTE: For this procedure, refer to FIGURE 8.3.

WARNING

The following procedure must be performed by a qualified technician.

The seat depth and back angle of the wheelchair, as well as the large wheel position directly relate to the stability of the wheelchair. Any change to one (1) or any com- bination of the three (3) may cause the wheelchair to decrease in stability. Use EXTREME caution when using a new seating position for the first time.

1.Loosen, but do not remove the rear hex screw that secures the back angle plate to the wheelchair frame.

2.Remove the front hex screw, washer, and locknut that secure the back angle plate to the wheelchair frame.

Part No.1106645 41 Nutron® Series