SECTION 9—UPHOLSTERY/SEAT POSITIONING STRAP

4.Pull the loose back canes out of the existing back upholstery.

5.Slide the loose back canes into the new back upholstery.

6.Secure the back canes to the wheelchair frame with the mounting screws and locknuts removed in STEP 1.

7.Secure the new back upholstery to the back canes with the two (2) existing upholstery mounting screws and washers.

Washer

NOTE: All four (4) mounting

screws and locknuts are shown.

 

Each fold‐down back cane uses

 

two (2) mounting screws.

Upholstery

Back Cane

Mounting

 

Mounting Screws

Screws

 

 

 

Back Upholstery

Locknuts

 

 

Wheelchair Frame

 

 

FIGURE 9.2 Replacing Back Upholstery

 

Replacing Seat Positioning Strap

NOTE: For this procedure, refer to FIGURE 9.3.

1.If necessary, remove the seat cushion from the seat upholstery.

2.Remove the two (2) rear phillips screws and washers that secure the seat upholstery and seat positioning strap to the crossbraces.

3.Remove the two (2) halves of the seat positioning strap from the crossbraces.

4.Position the two (2) new seat positioning strap halves between the seat upholstery and the crossbraces.

5.Reinstall the rear phillips screws and washers that secure the seat upholstery and seat positioning strap to the crossbraces.

NOTE: Washer is positioned on top of seat upholstery.

6. If necessary, reinstall the seat cushion onto the seat upholstery.

Part No.1106645

44

Nutron® Series

Page 44
Image 44
Invacare R51LXP, R50LX manual Replacing Seat Positioning Strap, Replacing Back Upholstery