Part No. 1110194 Rev A 1Tracer® SX5 Recliner Conversion Kit

Tracer® SX5 Recliner Conversion Kit

Assembly and Installation Instructions

SAVE THESE INSTRUCTIONS

NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. contact
Carrier/Dealer for further instruction.
SAFETY SUMMARY
To ensure the safe installation of the Recliner Conversion Kit, these instructions
MUST be followed:
WARNING
DO NOT install or use this equipment without first reading and understanding
these instructions and the Owners Manual, part number 1110550. If you are
unable to understand the Warnings, Cautions or Instructions, contact a
healthcare professional, dealer or technical personnel before attempting to
install this equipment - otherwise, injury or damage may occur.
AFTER conversion of the wheelchair and BEFORE USE of the recliner, read
the GENERAL GUIDELINES and RECLINER sections of the Owners Manual,
part number 1110550, for recliner operation instructions.
INSTALLATION WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
SX5 Recliners MUST have 8-inch casters installed. If the wheelchair originally
had 6-inch casters installed, seat-to-floor height adjustments MUST be made.
Seat-to-floor adjustments will also be necessary for certain 8-inch caster
mounting positions. Refer to the SEAT-TO-FLOOR section in the Owners
Manual, part number 1110550, for these adjustments.
SX5 Recliners CANNOT be used with the following options/accessories: one-
arm drive, solid folding seat, IV/O2 holder, O2 holder, Model 2218 IV rod,
amputee attachments or quick release axles. These options/accessories
MUST be removed prior to the conversion of the wheelchair.
SX5 Recliners MUST have properly installed and adjusted wheel locks and
anti-tippers. Refer to INSTALLING/ADJUSTING THE WHEEL LOCKS
and INSTALLING THE ANTI-TIPPERS in this instruction sheet. Failure to
observe this warning can result in serious injury.