Tracer® SX5 Recliner Conversion Kit 4Part No. 1110194 Rev A
INSTALLING THE RECLINING BACK
1. Remove the components listed in REMOVING EXISTING WHEELCHAIR
COMPONENTS in this instruction sheet.
2. Perform the following to complete installation of the reclining back:
Install the Rear Arm Sockets
Install the Offset Wheel Brackets
Install the Reclining Back Assembly
Install the Rear Wheels
Install/Adjust the Fork/Caster Assemblies
Install the Wheel Locks
Convert Flip Back Arms to Removable Arms
Install the Spreader Bar
Install the Rear Anti-tippers
Install the Headrest and Pillow

REMOVING THE FORK/CASTER ASSEMBLIES - WHEELCHAIRS

UNDER 20-INCHES WIDE ONLY (FIGURE 3)

1. Remove the dust cover.
2. Remove the locknut and nylon washer that secures the fork to the caster headtube.
3. Drop the front caster and fork out of the caster headtube.
4. Repeat STEPS 1-3 for the opposite fork/caster assembly.
Locknut
Dust Cover
Fork/Caster
Assembly
Nylon Washer
Caster Headtube
FIGURE 3 - REMOVING THE FORK/CASTER ASSEMBLIES -
WHEELCHAIRS UNDER 20-INCHES WIDE ONLY