Invacare Tracer SX5 installation instructions Installing the Reclining Back Assembly

Right

Reclining

Back

Tube

Flat Head

Socket Screw

Right Back Cane

Spacer	Reclining Back
	Assembly

Pivot Bushing

Mounting Hole

Top Clevis

Hex Screw

Cap Nut

Right Offset

Wheel Bracket

	Wheelchair
Cap Nut	Frame
Right U-Bracket

NOTE: Arm socket and back upholstery not shown for clarity.

NOTE: Only RIGHT side of wheelchair shown for clarity. Left side installs in a similar manner.

FIGURE 6 - INSTALLING THE RECLINING BACK ASSEMBLY

INSTALLING THE REAR WHEELS

Refer to REMOVING/INSTALLING THE REAR WHEELS in the Owner’s Manual, part number 1110550.

INSTALLING/ADJUSTING THE FORK/CASTER ASSEMBLIES

WARNING

SX5 Recliners MUST have 8-inch casters installed. If the wheelchair originally had 6-inch casters installed, seat-to-floor height adjustments MUST be made. Seat-to-floor adjustments will also be necessary for certain 8-inch caster mounting positions. Refer to the SEAT-TO-FLOOR section in the Owner’s Manual, part number 1110550, for these adjustments.

Wheelchairs Under 20-inches Wide ONLY.

Install 8-inch forks/caster assemblies.Refer to INSTALLING/REPLACING FORK ASSEMBLIES in the Owner’s Manual, part number 1110550.

All Wheelchair Widths.

Check that the front casters have been mounted properly for the rear wheel size. Refer to the SEAT-TO-FLOOR section in the owner’s manual, part number 1110550.

Part No. 1110194 Rev A 7 Tracer® SX5 Recliner Conversion Kit