SECTION 6—OPERATING INSTRUCTIONS
Connecting/Positioning the Nasal Cannula
CAUTION
To ensure proper breath detection and oxygen delivery, DO NOT use tubing length exceeding 25 ft (7.6 m).
NOTE: For this procedure, refer to FIGURE 6.8.
NOTE: Invacare recommends using the XPO2 with a 4 ft (1.2 m) cannula. The tubing must be connected to the XPO2 oxygen outlet as shown below.
NOTE: Replace the nasal cannula on a regular basis. Check with your equipment provider or physician to determine how often the cannula should be replaced.
NOTE: DO NOT share cannulas between patients.
1.Connect the nasal cannula to the XPO2 oxygen outlet port (Detail “A”).
2.Place the cannula over your ears and position the prongs in your nose as instructed by your health care provider or cannula manufacturer (Detail “B”).
Invacare XPO2™ | 30 | Part No 1148112 |
