JAI M7+ CL, CV-M4+, CV-M7+, M4+ CL operation manual Frame-delay read out Mode, Frame Delay

CV-M4+/M4+CL, CV-M7+/M7+CL

6.7. Frame-delay read out Mode

In this mode the pre selected exposure starts from the leading edge of the trigger pulse, H synchronous or H a-synchronous. It can be the 10 steps in normal or 1056 steps in programmable. SM=0 or SM=1. The resulting video is read out at the trailing edge of the trigger.

This mode will operate with full and partial scanning and with V binning (M4+ and M4+CL only). Partial scanning and binning in combinations is not allowed.

If smearless read out (SL=1) is used, the exposure starts with a delay 133H (5.23 msec.) after the trigger. An EEN pulse will indicate the active accumulation time, and a FEN pulse indicates that the resulting video is read out.

To use this mode:
Set function:	Trigger mode “Frame delay read out”	TR = 3
	“H synchronous accumulation”	HC=0, HC=1
	“Smearless readout”	SL=0, SL=1
	Polarity and other functions
Input:	Ext. trigger to LVDS/Camera Link or pin 10 on 12-pin connector.

Important notes on using this mode.

•The duration of the trigger should be longer than the exposure time + (>2H to <3V.) (>72.64∝sec to <120msec).

•The minimum trigger interval should be >(trigger pulse width + 1 frame). A new trigger must not be applied during the previous frame read out. (Before FEN is high).

Fig. 23 Frame Delay

- 19 -