JAI TM-1400 operation manual 02S Interface Cable optional

Page 12

Installation

When wiring the PD-12UU power supply directly, please note the following:

•The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

•Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and shorting.

•The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

•All connections must be properly insulated to prevent shorting.

2.2.7 (b) JAI PULNiX Power Cables

If you are using JAI PULNiX power cables such as the 12P-02S, please refer to the 12-pin connector pin-out diagram in “12-Pin Connector (TM-1400)” on page 6. The cable pin-out diagram is shown in Figure 7 below. The color-coded leads use Gray for Ground and Yellow for +12V.

FIGURE 7. 12P-02S Interface Cable (optional)

		+12 V
	GND (Gray)
Jack	Power (Yellow)
	Video Out (Red Coax)		}
	HD In (White Coax)
	VD In (Black Coax)

Analog

Frame Grabber

12P-02S Interface Cable

Pin#	Lead Color	Function	Pin#	Lead Color	Function
1	Gray	GND	7	Black coax	VD Input
2	Yellow	+12V DC	8	White coax shield	Reserved
3	Red coax shield	GND	9	White coax	HD Input
4	Red coax	Video	10	Brown	RXD
5	Orange coax shield	GND	11	Blue	Integration
6	Orange coax	VINIT IN	12	Black coax shield	TXD

Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires could cause the leads to short.

2.2.7 (c) Building Your Own Power Cable

Refer to the 12-pin connector pin-out in Section 2.2.2 (a on page 6. Connect the Ground lead to pin #1, and the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient current to properly power the camera.

2.2.7 (d) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly attach the power cable to the camera connector:

1.Rotate the connector while applying slight pressure until the keyways line up.

2.Press the connector into place until firmly seated.

3.Plug the power cord into the AC socket. This will power the camera up.

TM-1400 Series Progressive Scan Shutter Cameras