JBL DVD600II Front Panel Controls, Power Indicator surrounding, System Power Control When

DVD600II Front Panel Controls

96KHz 24bit

Main Power Switch: Press this button to apply power to the DVD600II. When the switch is pressed in, the unit is placed in a Standby mode, as indicated by the amber

Power Indicator surrounding the

System Power Control . This button MUST be pressed in to operate the unit. To turn the unit off and prevent the use of the remote control, this switch should be pressed until it pops out from the front panel so that the word “OFF” may be read at the top of the switch.

NOTE: This switch is normally left in the “ON” position.

System Power Control: When the

Main Power Switch is “ON,” press this button to turn on the DVD600II; press it again to turn the unit off. Note that the Power

Indicator in the center of the switch will turn green when the unit is on.

Power Indicator: This LED will be illu- minated in amber when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn green.

Disc Tray: Holds up to five DVD or CD discs that can be played one at a time in the DVD600II.

Disc Skip: Press twice in quick succes- sion to change the disc being played. This will move the tray forward to the next occupied position, skipping over the empty-disc positions.

Search Forward/Reverse: Press to move forward or backward through a disc at one of four speeds. Each press and release will increase the search speed, as indicated in the on-screen display. Once you have selected the desired speed, release the button and the disc will continue to search at fast speed. To resume normal playback speed, press the

Play Button .

Open/Close Button: Press to open or

close the Disc Tray . Upon closing the disc tray, the On Screen Library system will begin to identify all loaded discs.

Skip Forward/Reverse: Press to move forward or backward through the music tracks or chapters on a disc.

Stop: Press once to place the disc in the Resume mode, which means that playback will stop, but (as long as the tray is not opened or the disc changed) DVD playback will continue from the same point on the disc when the Play button is pressed again. Resume will also work if the unit was turned off. To stop a disc and have play start from the beginning, press the button twice.

Play/Pause: Press to begin playback of a disc, or to momentarily pause playback. If a DVD is playing, action will freeze and a still picture will be displayed when the button is pressed.

Direct Access Buttons: Press one of these buttons to play any of the five discs loaded in the Disc Tray.

Information Display: This display con- tains a variety of indicators that provide infor- mation about the status of the DVD600II and the disc currently playing.

Display Dim: Press this button to adjust the brightness of the Information Display by 50% or to turn the display off completely in the following order: FULL BRIGHTNESS ➔ HALF BRIGHTNESS ➔ OFF ➔ FULL BRIGHTNESS.

Remote Sensor: The sensor that receives the infrared commands from the remote control is behind this area. Do not cover or obscure this part of the front panel, in order to avoid a malfunction with the remote.

19