If your Web Xpander is connected using network configurations 1 or 2 (above) you may need to manually set the IP address of the PC or the Web Xpander.

Manually Configuring Web Xpander Network Settings

You can send commands to the Web Xpander via the STARGATE by using the “ASCII” button on the MegaController in WinEVM.

1.Start WinEVM

2.Click the MegaController icon

3.Click the ASCII button

4.Select “Out of Controller” and “Com1”

5.Type one or more of the following network configuration commands to configure your Web Xpander to function on your network

Note: Once you can access the Web Xpander via the web (Internet Explorer) all of these settings are accessible from the “Settings” button.

A full listing of Web Xpander commands is available in Appendix A

Click “Send” to issue ASCII data. Click “OK” to close.

“Send ASCII” dialog accessed by clicking ASCII from

the WinEVM MegaController

Command

Description

Example

:ipaddr=

Sets the IP Address

:ipaddr=192.168.0.20

:ipmask=

Sets the Netmask

:ipmask=255.255.255.0

:ipgate=

Sets the Gateway Address

:ipgate=192.168.0.1

:dns=

Sets the DNS Address

:dns=192.168.0.1

:dhcp=

Enabled/Disables DHCP

:dhcp=1 or :dhcp=0

:smtp=

Sets the outgoing (SMTP) mail

:smtp=smtp.comcast.net

 

server name

 

:user=

Sets the user name required for

:user=myname

 

access

 

:pass=

Sets the password required for

:pass=mypass

 

access

 

:webport=

Sets the port (default = 80) for

:webport=80

 

the web server

 

Page 7
Image 7
JDS Uniphase RS-232 operation manual Manually Configuring Web Xpander Network Settings, Command Description Example