MCDA1
Installation (continued)
Mounting the MWR32 Controller
Choose and Prepare Location
The MWR32 can be installed in a standard 2 1/8" gauge cutout. The required mounting depth will vary, but at least 2 1/2" is needed to mount the controller.
If a standard cutout is not available, mark an area for the cutout and carefully cut a 2 1/8” opening with a hole saw. A jig saw can be used but may cause difficulty because of the small radius of the opening.
Be sure to check behind the panel for wiring harnesses, steering cables, hydraulic lines, fuel lines, gas tanks, etc. Also check to make sure you can get behind the dash panel, bulkhead, etc. to attach the mounting bracket.
Important: Do not mount unit where it can be submerged.
Template
Plantilla
Gabarit
2 1/8”
65 mm.
Mounting the Remote
The MWR32 comes with a plastic mounting plate, a plastic mounting base and an aluminum mounting bracket.
Attach the plastic mounting plate to the plastic mounting base, and insert into the cutout. Fasten to the aluminum mounting bracket with the included screws.
Finally, route the remote control cable through the mounting plate and base, and attach the remote to the plastic mounting plate by aligning the four hooks on the holder with the four slots on the remote.
Wiring
Once the remote has been mounted, connect the cable to the main unit using the 20 foot extension cable supplied.
Up to two additional extension cables (MWREXT) may be purchased and used to extend the reach of the remote up to 60 feet.
When connecting the cables, be sure to route the extension cable away from sharp objects, corners and places where it might get pinched, as this could affect performance and cause damage to the unit.
Mounting the Remote
Armado del Control Remoto
Fixation de la Télécommande
SHIFT SCN
POWER VOL
SEL /
MENU
VOL
MP3 | |
| MWR32 |
MARINE | RECEIVER + |
| |
RPT | CDC |
| RDM |
| INT |
| 7 |
| 8 |
MODE | SW |
| BAND | ENTER | |
|
| ||
MUTE | DISP | ||
|
| ||
| AS/PS | DIM | |
|
| ||
9 | MP3 | LD | |
0 | |||
| |||
15
