Electrical

4. Close the blade cover and secure with four knobs.		source, or that the fuses have been removed or break-
Electrical		ers tripped in the circuit in which the saw will be
Electrical		connected. Make sure you put a warning placard
Observe the following when connecting to the power		on the fuse or circuit breaker to prevent accidental
source. (The cut-off saw wiring diagrams are provided		electrical shock.
in Figures 17 and 18.)	2.	If you are installing the motor power cord into a re-
WARNING: JET RECOMMENDS THAT ANY WIRING		ceptacle, make sure to use the appropriate plug.
WARNING: JET RECOMMENDS THAT ANY WIRING	3.	If you are using hard-wired connections to a junc-
INVOLVING HARD WIRING OF THE SAW TO A	3.	If you are using hard-wired connections to a junc-
INVOLVING HARD WIRING OF THE SAW TO A		tion box, connect the wires in the box, and close
BRANCH, ORANY CHANGE OF VOLTAGE SUPPLIED		tion box, connect the wires in the box, and close
BRANCH, ORANY CHANGE OF VOLTAGE SUPPLIED		the box.
TO THE MOTOR BE PERFORMED BY A LICENSED		the box.
TO THE MOTOR BE PERFORMED BY A LICENSED	4.	Install the fuses or reset the breaker.
ELECTRICIAN.	4.	Install the fuses or reset the breaker.
1. Make sure the saw is disconnected from the power	5.	The saw is now ready for service.
1. Make sure the saw is disconnected from the power

Figure 21: Model J-7020 cut-off saw wiring diagram

	115 Volt				220 Volt
1	3	2	4	1	2	3	4