Juniper Networks 5000 SERIES manual NetScreen-5400 Interfaces, Configurable Interfaces

Chapter 3 Configuring the Device

NetScreen-5400 Interfaces

A NetScreen-5400 contains one management module (in slot 1) and up to three SPMs. You can use a 5000-M or a 5000-M2 management module in slot 1. In the illustrations below, the device contains three 5000-8G SPMs.

Console Port Modem Port MGT Port

HA Ports

SPM, slot 2

SPM, slot 3

SPM, slot 4

ethernet4/1 ethernet4/5

ethernet4/2 ethernet4/6

ethernet4/3 ethernet4/7

ethernet4/4 ethernet4/8

Configurable Interfaces

The configurable interfaces available on a NetScreen-5000 Series device are as follows:

Interface Type	Description
Ethernet interfaces	ethernetn1/n2 specifies a physical ethernet interface, denoted by an interface
	module in a slot (n1) and a physical port (n2) on the module.
	ethernetn1/n2.n3 specifies a logical interface, denoted by an interface
	module in a slot (n1), a physical port (n2) on the module, and a logical
	interface number ( .n3). You create logical interfaces using the set interface
	command.
Layer-2 interfaces	vlan1 specifies the interface used for management and VPN while the
	NetScreen device is in Transparent mode.
Tunnel interfaces	tunnel.n specifies a tunnel interface. Use this interface for VPN traffic.
Function interfaces	mgt specifies a dedicated management interface bound to the MGT zone.
	ha1 and ha2 specify the names of the dedicated HA ports.

24 User’s Guide