Juniper Networks 5XT, 5200, 208, 204, 500, 5400 manual

Juniper Networks NetScreen Release Notes

•02986 – SSHv2 with RADIUS authentication failed to authenticate external users properly.

•02985/02996 – The Juniper NetScreen-5000 Series systems sometimes failed from memory corruption due to kernel locking.

•02975 – While performing a virus scan with the anti-virus engine, the anti- virus update failed, and no traffic could pass through a Juniper Networks security appliance because the policies blocked it, and the device failed repeatedly.

•02972 – When you tried to transfer large files using SCP, the connection closed before the transfer completed.

•02952 – A code loop in a SIP disconnect state occurred and resulted in a core the device failing when disconnecting a SIP call over a Cisco VOIP (Voice Over IP) network.

•02941 – When you configured a device with a DIP (Dynamic IP) and traffic shaping, the first traffic the device sent failed to reach its destination.

•02933 – While attempting to age out specific sessions, the device sometimes went into an infinite loop causing the watchdog timer to cause the device to fail.

•02921 – A Juniper NetScreen-5400 stopped accepting all traffic after you reset the device and then unset a policy with multiple services.

•02918 – A Juniper NetScreen-5000 Series system sometimes could not support HTTPS when the system occurred in an NSRP active-passive environment in Transparent mode when you used HTTPS to manage both the primary and backup devices.

•02915 – An invalid pointer reference between FTP control channel and data caused the device to fail.

•02913 – Although a session on the device has a timeout of one second, when the session exceeded the timeout, the device did terminate the session.

•02911 – In some cases, sessions on the Juniper NetScreen-5000 Series systems never aged out even if there was no response to them.

•02908 – When you lost a Web and SSH connection to the primary device in an active-passive HA configuration, you could not connect to the primary device using an SSH or WebUI session, although you could connect to the backup device.

•02906 – You were unable to ping from one device to another over a VPN between two devices that were each in transparent mode running ScreenOS 5.0.0rX.

•02893 – When high amounts of traffic transferred across the Fast Ethernet port on the Juniper NetScreen-500, the data could become corrupted.

ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 10 of 42