Juniper Networks 5400, 5200, 208, 204, 500, 5XT manual

Juniper Networks NetScreen Release Notes

•02709 – When you set a manual VPN authentication setting to NULL on a Juniper Networks security appliance, the device failed because a Null length is invalid.

•02707 – When performing an anti-virus scan on a Juniper NetScreen-5GT device, the device displayed an error-constraint-drop status.

•02699 – When multiple interfaces belonged to different Vsys had the same IP address and subnet mask, VPN traffic to these subnets could pass to the wrong Vsys.

•02609 – The primary Juniper NetScreen-5200 device in an active-passive NSRP cluster failed, which caused a failover from the primary to the backup device.

•02694 – ScreenOS did not send discovered SCREEN occurrences to Security Manager when Security Manager imported a configuration from a device.

•02692 – The DIP (Dynamic IP) allocation failed and halted traffic entering the device, requiring the DIP allocation mechanism to be reset every two hours.

•02688 – The CLI provided no maximum value check for BGP hold time entered on a device, incorrectly allowing you to enter any value for the hold time. If the value was greater than the maximum hold time setting of 65,525, the device incorrectly accepted the value, and the output from the get hold- time command incorrectly displayed it as a negative number.

•02687 – Traffic shaping did not work properly when the traffic shaping policies traversed a route-based VPN on a device.

•02685 – You could not unset the sql alg using the unset flow sql-algcommand on Juniper NetScreen-5000 Series devices.

•02679 – Some devices generated multiple logs for information associated with the self log.

•02670 – When a Juniper NetScreen-5XT device obtained a new IP address from a DHCP server, one of the static routes did not update the default gateway with the proper IP address and DHCP payload information assigned to the device.

•02668 – A VPN tunnel incorrectly displayed two different ESP sequence numbers which are associated with two different ASICs on the Juniper NetScreen-5000 Series devices.

•02664 – Packets were sent out with the MAC address of the inactive VSI instead of the active VSI address in an active-active VSI cluster.

•02663 – You could not manage two of the secondary IP addresses on an interface of the Juniper NetScreen-100p in the WebUI.

•02660 – After importing a CA (Certificate Authority) certificate into a device and then rebooting the device, the device removed the certificate.

ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 17 of 42